Stratus Coupe V6-3.0L VIN H (2001)
STEP 6. Check the harness wire between daytime running light-ECU connector A-26 and ignition switch.
NOTE: After checking intermediate connector C-209 and junction block connector C-301 and C-310, check the wires. If intermediate connector C-209
and junction block connector C-301 and C-310 are damaged, repair or replace them. Refer to Harness Connector Inspection.
Q: Are the harness wire between daytime running light- ECU connector A-26 and ignition switch in good condition?
YES: Go to Step 7.
NO: Repair or replace it. Refer to Harness Connector Inspection.
STEP 7. Check the daytime running light ground circuit at the daytime running light connector A-26.
1. Disconnect the daytime running light connector A-26.
2. Measure the resistance between terminal 6 and ground.
Q: Is the resistance less than 2 ohms?
YES: Go to Step 9.
NO: Go to Step 8.
