Stratus Coupe V6-3.0L VIN H (2001)
1. Apply the specified grease to the inner shaft serration, and then press the inner shaft assembly into the TJ case.
Specified grease: Mopar Multi-mileage Lubricant Part No. 2525035 or equivalent
CAUTION: The driveshaft joint uses special grease. Do not mix old and new or different types of grease.
2. Fill the TJ case with repair kit grease and insert the driveshaft, and then refill the TJ case with repair kit grease.
Grease quantity:
<2.4L ENGINE> 100 ± 10 grams (3.5 ± 0.4 ounce)
<3.0L ENGINE> 105 ± 10 9 (3.7 ± 0.4 ounce)
NOTE: The grease in the repair kit should be divided in half for use, respectively, at the joint and inside the boot.
>>G<< TJ BOOT BAND (SMALL)/TJ BOOT BAND (LARGE) INSTALLATION
1. Position the TJ outer race so that the distance between the boot bands is at the standard value.
Standard value (A): 85 ± 3 mm (3.3 ± 0.12 inch)
2.
Remove part of the TJ outer race to release the air pressure inside the boot.
BJ Boot Replacement
BJ BOOT REPLACEMENT
1. Remove the boot bands (large and small).
NOTE: The BJ boot bands cannot be re-used.
2. Remove the BJ boot.
