Stratus Coupe V6-3.0L VIN H (2001)
3. Use some narrow-gauge wire [approximately 0.5 mm (0.02 inch) diameter] to compress the springs, and then tie the narrow-gauge wire a to
the slits in the guide.
4. Insert the end of the lowering wire into the wire hole at the bottom of the drum, and then wrap the bottom so that there is no slackness in the
wire.
5. Install the lifting wire to the drum as following:
a. Insert the end of the lifting wire into the wire hole at the top of the drum.
b. Raise the front of the drum until the drum is vertical, and then position the lifting wire in the groove of the drum.