dodge Workshop Repair Guides

Dodge Workshop Service and Repair Manuals

Headliner|Service and Repair|Page 6011 > < Headliner|Service and Repair
Page 2
background image

Fig. 17

12. Using Special Tool 6967, disengage headline rear locating clip holding headlining to roof above rear window (Fig. 17).
13. Pull down on headliner around sun roof to disengage hook and loop fastener, if equipped.
14. Disconnect the sunroof module electrical connector, if equipped.
15. Recline front seats.
16. Tilt steering wheel fully up.
17. Move shifter fully rearward.
18. Lower headliner.
19. Remove headliner through passenger front door opening.

INSTALLATION 

NOTE:  Do not remove the cardboard light blocker from the reading lamp.

1. Transfer front map lamp and bracket.
2. Transfer sunroof switch.
3. Transfer rear dome lamp.
4. Fully recline both front seats.
5. Tilt steering wheel fully up.
6. Move shifter fully rearward.
7. Move headliner into vehicle through front passenger door.
8. Lay headlining wiring harness out along A-pillar to prevent capturing between headlining and roof.
9. Install left inboard sun visor support.

10. Align rear locator with mating hole in roof bow and press upward on headlining until rear locator engages.
11. Install coat hooks.
12. Install assist handles.
13. Install sun visors.
14. Connect electrical connector to sunroof switch, if equipped.
15. Push upward on sunroof switch to engage into switch retainer, if equipped.
16. Push upward on headlining around sunroof opening to engage hook and loop fasteners, if equipped.
17. Connect map lamp electrical connector, if equipped.
18. Confirm the headliner is not hung up on the side air bag deployment ramp.
19. Push upward on map lamp to engage lamp to headlining, if equipped.

Headliner|Service and Repair|Page 6011 > < Headliner|Service and Repair