Stratus Sedan L4-2.4L VIN X (2003)
4. Remove support isolators from muffler supports.
5. Remove muffler/pipe assembly from resonator pipe.
NOTE:
-
Band clamps are spot welded to exhaust system. If a band clamp must be replaced, the spot weld must be ground off the exhaust pipe.
-
When replacement is required on any component of the exhaust system, it is most important that original equipment parts (or their equivalent)
be used for the following reasons:
-
To insure proper alignment with other parts in the system.
-
Provide acceptable exhaust noise levels and does not change exhaust system back pressure that could affect emissions and performance.
INSTALLATION
NOTE: Always work from the front to rear of exhaust system when aligning and tightening exhaust system components.
1. Loosely install muffler/pipe assembly onto resonator pipe.
2. Install support isolators to muffler supports.
3. Align muffler/pipe assembly to maintain position and proper clearance with underbody parts. All support isolators should have equal load on them.
Tighten band clamp to 54 Nm (40 ft. lbs.).
4. Connect ground strap to muffler.
5. Lower vehicle.
