Stratus Sedan L4-2.4L VIN X (2003)
3. Inspect BCM connectors and wires for proper connection.
4. Remove BCM from Junction Block. Check for battery voltage at terminal JB-12 and ignition feed at terminal JB-6 of BCM. Refer to the
appropriate wiring information.
5. If voltage not OK, repair as necessary.
No Tone When Headlamps Are ON, Ignition Switch Is OFF And Driver's Door Is Open.
1. Check left door jamb switch for good ground when driver's door is open.
2. Use DRB III scan tool to perform PCI data bus diagnostics on BCM for battery, ignition switch input, headlamp and driver's door input and Chime
Output Test.
3. Check headlamp switch.
4. Inspect BCM connectors and wires for proper connection.
5. Remove BCM from Junction Block. Check for battery voltage at terminal JB-12 and ignition feed at terminal JB-6 of BCM. Refer to the
appropriate wiring information.
6. If voltage not OK, repair as necessary.
No Tone When Ignition Key Is Left In Ignition Switch And It Is In The OFF Position With Driver's Door Is Open
1. Check left door jamb switch for good ground when drivers door is open.
2. Use DRB III scan tool to perform PCI data bus diagnostics on BCM for battery, ignition switch input, key-in-switch and driver's door input and
Chime Output Test.
3. Check key-in switch.
4. Inspect BCM connectors and wires for proper connection.
5. Remove BCM from Junction Block. Check for battery voltage at terminal JB-12 and ignition feed at terminal JB-6 of BCM. Refer to the
appropriate wiring information.
6. If voltage not OK, repair as necessary.
Chimes Continue When Headlamps Are Turned OFF And/or Key Is Removed From Ignition
1. Use DRB III scan tool to perform PCI data bus diagnostics on BCM for headlamp or key-in-ignition inputs.
2. Check wiring for a grounded condition between key-in switch and BCM. Check headlamp switch to BCM wiring for short to battery.
3. Inspect BCM connectors and wires for proper connection.
