Stratus Sedan L4-2.4L VIN X (2003)
EQUIPMENT REQUIRED
REPAIR PROCEDURE:
NOTE:
WHENEVER A PCM/TCM IS REPLACED OR REPROGRAMMED, THE SOFTWARE IN THE CONTROLLER AND DRB III(R) MUST BE
VERIFIED AS HAVING THE LATEST REVISION LEVEL.
1.
Connect a battery charger and set as close to 14 volts charge as possible.
2.
Flash the PCM using the MDS2 (Mopar Diagnostic System) and DRB III(R).
NOTE:
DUE TO THE PCM REPROGRAMMING PROCEDURE, A DTC MAY BE SET IN OTHER MODULES (TCM, BCM, MIC, SKIM, ETC.)
WITHIN THE VEHICLE, IF SO EQUIPPED. SOME DTC'S MAY CAUSE THE MIL TO ILLUMINATE. ALL DTC'S RELATE TO A LOSS OF
COMMUNICATIONS WITH THE MODULE THAT IS BEING REPROGRAMMED. CHECK ALL MODULES, RECORD THE FAULTS, AND
ERASE THESE FAULTS PRIOR TO RETURNING THE VEHICLE TO THE CUSTOMER. ERASE ANY FAULTS IN THE PCM ONLY
AFTER ALL OTHER MODULES HAVE HAD THEIR FAULTS ERASED.
NOTE:
THE FOLLOWING STEPS ARE REQUIRED BY LAW.
3.
Type the necessary information on the Authorized Software Update Label" p/n 04669020 (Fig. 1). Attach the label to the PCM and/or TCM as
necessary and cover the label(s) with the clear plastic overlay.
