Stratus Sedan L4-2.4L VIN X (2003)
20.
Stand the steering column on end so the outer race of the upper bearing is supported on a 1-1/16 in. socket. Using a 7/8" deep well socket or other
suitable tool placed against the lower bearing outer race tap the bearing downward several times with a brass hammer until the bearing is fully
seated. Use a 0.005" feeler gauge to make sure no clearance exists between the lower casting and the outer race of the lower bearing. (Fig. 2)
21.
Install the original steering column shaft, except for vehicles built prior to Oct. 1, 2001 (MDH 1001Xx) install revised shaft p/n 04690852AA,
revised wedge, p/n 04690570, and **revised spring, p/n 05057088AA.**
22.
Thread the steering wheel bolt into the steering column shaft.
