Stratus Sedan L4-2.4L VIN X (2003)
5.
Add bead of urethane along entire top edge of windshield per (Fig. 1).
6.
Install revised windshield reveal molding, p/n 04806123AA, to the top of the windshield.
7.
Press along entire length of windshield reveal molding with fiber stick per (Fig. 2) to ensure proper bond to glass. Finesse as necessary to ensure
proper appearance of molding. Leading edge and "tail" of molding should not be wavy in appearance. The tail of the reveal molding should be
slightly underflush to the top of the roof. If the tail of the reveal molding is grossly overflush the gap between the windshield and the downstanding
surface of the roof is too small and the windshield must be removed and refitted to achieve a larger windshield to roof gap. It is also important that
the gap be consistent all the way across in order to achieve an optimum appearance.
8.
Install the "A" pillar moldings. Tighten the fasteners to 2 Nm (18 in. lbs.).
