Stratus Sedan V6-2.7L (2001)
2. Install and torque the 4 power brake vacuum booster mounting nuts to 29 Nm (250 inch lbs.) torque.
3. Using Lubriplate, or an equivalent, coat the surfaces of the brake pedal pin that contact the power brake vacuum booster input rod.
4. Connect power brake vacuum booster input rod to brake pedal pin and install a NEW retaining clip. Use only a new retainer clip DO NOT USE
the old clip.
5. Install the purge solenoid to the left frame rail and connect its wiring harness.
6. Install the vacuum hoses on the booster check valve.
7. Install the master cylinder and connect the fluid level switch.
8. If equipped, install speed control servo on the mounting studs. Install the 2 speed control servo bracket mounting nuts and tighten to a torque of 6
Nm (55 inch lbs.). Install electrical connector and vacuum hose on speed control servo.
9. Install the throttle cable, and if equipped, the speed control cable on the cam of the throttle body assembly.
10. Install the remote ground cable on the ground stud located on the left strut tower. Install and securely tighten the ground cable attaching nut.
11. Check brake lamp operation. If required, adjust brake lamp switch as necessary.
12. Road test vehicle to ensure proper operation of the vehicles brake system and speed control.
