Stratus Sedan V6-2.7L (2001)
Fig.7 Clutch Field Coil Snap Ring
13. Remove snap ring from compressor hub and remove clutch field coil. Slide clutch field coil off of the compressor hub.
INSTALLATION
1. Install clutch field coil and snap ring.
2. Install clutch coil wire harness retaining clip on the front of the compressor and tighten the screw.
3. Align rotor assembly squarely on the front compressor housing hub.
Fig.8 Clutch Pulley Install
4. Install pulley bearing assembly with Installer C-6871. Thread installer on the shaft, then turn the nut until the pulley assembly is seated.
5. Install external snap ring with the bevel side of the snap ring facing outward. Verify snap ring is seated.
CAUTION: If snap ring is not seated in the groove it will vibrate out and cause clutch failure and severe compressor damage will occur.
6. Install compressor shaft key and the original clutch shims on the compressor shaft.