Stratus Sedan V6-2.7L (2001)
Suspension Strut / Shock Absorber: Description and Operation
Front
DESCRIPTION - SHOCK ASSEMBLY
The front shock assembly and suspension of the vehicle is supported by coil springs positioned around shock absorbers. The springs are contained
between an upper seat located in the upper mounting bracket and a lower spring seat on the shock absorber.
The top of each shock absorber is bolted to a cast shock absorber/upper control arm bracket which is bolted to the shock tower of the vehicle using 4
mounting bolts.
The bottom of the shock absorber attaches to a clevis bracket using a pinch bolt. The clevis bracket attaches to the lower control arm of the vehicle using
a through-bolt and prevailing torque nut.
A coil spring is housed within each shock assembly. Coil springs are rated separately for each corner or side of the vehicle depending on optional
equipment and type of vehicle service. If the coil springs require replacement, be sure that the springs needing replacement, are replaced with springs
meeting the correct load rating and spring rate for the vehicle and its specific options.
The components of the shock assembly listed below are serviceable if found to be defective:
-
Upper mounting bracket
-
Upper spring isolator
-
Dust shield
-
Cup
-
Jounce bumper
-
Coil spring
-
Shock absorber
-
Lower spring isolator
The shock absorber/upper control arm mounting bracket also provides a pivotal mounting point for the upper control arm.
OPERATION - SHOCK ASSEMBLY
