Stratus Sedan V6-2.7L (2001)
11. Separate halfshaft from steering knuckle (Fig. 9). If difficulty is encountered separating halfshaft from knuckle, DO NOT strike halfshaft with a
hammer to break free. Install Puller 1026 (Fig. 10) as shown in to press shaft out of hub/bearing assembly.
CAUTION: When inserting pry bar between inner tripod joint and transaxle case, care must be used to ensure no damage occurs to oil seal in
transaxle case.
12. Support the outer end of the halfshaft assembly. Insert a pry bar between inner tripod joint and transaxle case (Fig. 11). Pry against inner tripod
joint, until tripod joint retaining snap ring is disengaged from transaxle side gear.
