Stratus Sedan V6-2.7L (2001)
Fig. 10
12. If a low viscosity urethane adhesive is used, install compression spacers on the fence around the windshield opening (Fig. 10).
13. Apply a 10 mm (0.4 in.) bead of urethane on center line of windshield fence.
14. With the aid of a helper, position the windshield over the windshield opening. Align the reference marks at the bottom of the windshield to the
support spacers.
15. Slowly lower windshield glass to windshield opening fence. Guide the molding into proper position as necessary. Push windshield inward molding
is flush to roof line and A-pillars.
16. Clean access urethane from exterior with Mopar(R) Super Kleen or equivalent.
17. Apply 150 mm (6 in.) lengths of 50 mm (2 in.) masking tape spaced 250 mm (10 in.) apart to hold molding in place until urethane cures.
18. Install windshield side moldings and drip rail weatherstrips.
19. Install cowl cover and wipers.
20. Install inside rear view mirror.
21. After urethane has cured, remove tape strips and water test windshield to verify repair.
