Stratus Sedan V6-2.7L VIN R (2002)
1. Remove door trim panel and watershield.
Fig. 31
2. Remove the lift plate attaching screws (Fig. 31).
3. Remove nut attaching top of guide bar to inner door panel.
4. Using a suitable allen wrench, hold jack screw stationary while removing nut attaching bottom of guide bar to inner door panel.
Fig. 32
5. Remove guide bar from vehicle and remove through access hole in inner door panel (Fig. 32).
INSTALLATION - JR-27 (Convertible)
1. If a new guide bar is being installed, preset bottom jack screw using old guide bar as a reference.
2. Position rear guide bar on vehicle.
3. Using a suitable allen wrench, hold jack screw stationary while installing nut attaching bottom of guide bar to inner door panel.
