Stratus Sedan V6-2.7L VIN R (2002)
Body Emblem: Service and Repair
EXTERIOR NAME PLATES
REMOVAL - FOAM TAPE
1. Mark reference points before removing.
2. Using a heat gun gently apply heat in a circular motion to loosen the adhesive bond.
3. Using a trim stick C 4755 or equivalent, gently pry up at corners and remove.
4. Clean off all traces of adhesive or double sided tape from the panel with a general purpose adhesive remover.
INSTALLATION - FOAM TAPE
1. Clean panel surface with isopropyl alcohol.
2. Align badging to reference points.
3. Install and press securely to full adhesive contact.
4. Clean away any reference points.
