Stratus Sedan V6-2.7L VIN R (2002)
Keyless Entry Transmitter: Service and Repair
STANDARD PROCEDURE - TRANSMITTER PROGRAMMING
The Remote Keyless Entry (RKE) Transmitter(s) can be programmed with the use of the DRB III scan tool, or by the customer.
Programming Transmitter With The DRB III Scan Tool
For procedures on programming the transmitter(s) with the DRB III scan tool, refer to the proper Body Diagnostic Procedures Manual.
Programming By Customer
For a customer to be able to program RKE transmitters themselves, at least one RKE transmitter must be programmed already. This procedure is to
add additional transmitters. If all transmitters are lost, the DRB III scan tool must be used to program the new transmitter(s).
1. With ignition ON, press and hold the RKE UNLOCK button for at least 4 seconds. While holding the UNLOCK button, press the PANIC button.
2. Verify that the Body Control Module (BCM) chimes to indicate that you have entered RKE transmitter programming mode.
3. To program the RKE transmitters, press and hold the LOCK and UNLOCK buttons simultaneously for at least 3 seconds, and then press the
UNLOCK button.
4. Verify that the BCM chimes after each transmitter is programmed.
5. To exit program mode, turn OFF ignition or wait 32 seconds. The BCM will chime again.
