Stratus Sedan V6-2.7L VIN R (2002)
Brake Light Switch: Service and Repair
REMOVAL
1. Remove the brake lamp switch from its bracket. The brake lamp switch is removed by depressing and holding the brake pedal while rotating brake
lamp switch in a counter-clockwise direction approximately 30 degrees. Pull the switch rearward and remove it from its mounting bracket.
2. Disconnect the wiring harness connector from the switch.
INSTALLATION
NOTE: Prior to installing brake lamp switch into the mounting bracket, the plunger must be moved to its fully extended position using the procedure
in Step 1.
1. Hold the brake lamp switch firmly in one hand. Using the other hand, pull outward on the plunger of the switch until it has ratcheted out to its fully
extended position.
2. Connect the wiring harness connector to the brake lamp switch.
3. Install the brake lamp switch in the brake pedal bracket. Install it using the following procedure:
-
Depress the brake pedal as far down as possible.
-
Install the switch in its bracket by aligning the index tab on the switch with the slot in the mounting bracket.
-
When the switch is fully seated in its bracket, rotate the switch clockwise approximately 300 to lock the switch into place. It should be aligned
straight up and down.
