Stratus Sedan V6-2.7L VIN R (2002)
Battery Tray: Service and Repair
Battery Holddown
REMOVAL
1. Disconnect and isolate the negative battery cable remote terminal from the remote battery post.
2. Raise and support the vehicle.
3. Remove the left front wheel and tire assembly from the vehicle.
4. Remove battery splash shield. Refer to the Body section for the procedure.
5. Remove the short bolt from the battery hold down and remove the hold down.
INSTALLATION
1. Install the battery hold down and install the hold down bolt. Torque to 14 Nm (150 in. lbs.).
2. Install battery splash shield. Refer to the Body section for the procedure.
3. Connect the negative battery cable.
