Stratus Sedan V6-2.7L VIN T FFV (2003)
5.
Locate leading brake shoe hold down spring. Remove the spring, all washer(s), and pin, then discard them, (Fig. 1).
6.
Remove bottom of the leading shoe from the lower anchor area, move shoe rearward and disconnect lower return spring and discard it.
7.
Install the revised lower anchor return spring from kit, p/n 50010186AA.
8.
Reinstall the leading shoe to the lower anchor.
9.
Install the revised hold down spring, pin and washer from kit, p/n 50010186AA onto the leading shoe.
10.
Remove the trailing shoe hold down spring, all washer(s), and pin, then discard them.
11.
Install the revised trailing shoe hold down spring, pin and washer from kit, p/n 50010186AA, onto the trailing shoe.
12.
Visually inspect that both new hold down springs and lower anchor are fully seated with the hold down washers are locked.
NOTE:
ENSURE THE BRAKE DRUM IS FREE OF ANY FOREIGN MATERIAL/OBJECTS PRIOR TO INSTALLATION.
13.
Reinstall the brake drum and tire/wheel assembly onto the wheel studs.
14.
Reinstall lug nuts and torque to 130 Nm (100 ft. lbs.) in a "criss-cross" pattern.
15.
Repeat step 2 through 15 on the opposite side of the vehicle.
16.
Lower the vehicle.
POLICY:
Reimbursable within the provisions of the warranty.
TIME ALLOWANCE:
