Viper V10-488 8.0L (1992)
Camshaft Position Sensor: Service and Repair
Camshaft Position Sensor
REMOVAL
1. Disconnect negative battery cable.
2. Disconnect sensor electrical connector.
3. Remove sensor mounting bolt.
4. Using two small screwdrivers, carefully pry sensor from timing chain cover.
5. Remove sensor from vehicle.
6. Inspect condition of o-ring.
INSTALLATION
1. Apply a small amount of clean motor oil to sensor o-ring.
2. Install the sensor into the timing cover with a slight rocking motion. Push the sensor all the way into the cover until the sensor contacts the cam
gear.
3. Install sensor mounting bolt and torque to 11 Nm (95 in-lbs).
4. Connect sensor electrical connector.