Viper V10-8.3L VIN Z (2004)
49.
Install all timing chain cover bolts and tighten to 100 in-lbs (11 N.m) using the sequence found in Figure 9, then using the same sequence, tighten
the bolts to 200 in-lbs (22 N.m).
50.
Using crank seal installation tool MD998306, install the front crankshaft seal to the proper depth (Figure 10).
51.
If the camshaft position sensor was removed due to damage, slide a new sensor (P/N 05245084) into the timing chain cover sensor hole until it
makes light contact with raised edge on the camshaft sprocket. Tighten the sensor retention bolt to 100 in-lbs (11 N.m).
52.
Raise the vehicle.
53.
Install the accessory drive belt tensioner and nut to the appropriate position and tighten to 30 ft-lbs (41 N.m).
54.
Clean any coolant and oil from the oil pan using MOPAR brake cleaner (P/N 04897150AB).
55.
Inspect the oil pickup tube 0-ring (Figure 6). Install a new 0-ring (P/N 06032920) if it is damaged.
56.
Install the oil pickup tube into the timing chain cover, seating the 0-ring (Figure 6).
57.
Install oil pickup tube flange onto the timing chain cover (Figure 6). Tighten the bolt to 100 in-lbs (11 N.m).
58.
Install the oil pickup tube main bearing stud nuts to secure the oil pickup tube straps (Figure 6). Tighten the nuts to 200 in-lbs (22 N.m).
