dodge Workshop Repair Guides

Dodge Workshop Service and Repair Manuals

Air Bag System|Page 725 > < Refrigerant Oil|Capacity Specifications|Page 719
Page 1
background image

Repairs and Inspections Required After a Collision: Service and Repair
Air Bag System

SERVICE AFTER AN AIRBAG DEPLOYMENT DRIVER AIRBAG

After a Driver Airbag has been deployed due to a collision, the following MUST be replaced:

-

Driver Airbag 

-

Clock Spring Assembly 

-

Steering Wheel 

-

Complete Steering Column Assembly 

All other airbag and vehicle components should be closely inspected following any airbag deployment, but are to be replaced only as required by the
extent of the visible damage incurred.

PASSENGER AIRBAG

After a Passenger Airbag has been deployed due to a collision. the following MUST be replaced:

-

Passenger Airbag 

All other airbag and vehicle components should be closely inspected following any airbag deployment, but are to be replaced only as required by the
extent of the visible damage incurred.

SEAT BELTS AND TENSIONERS

After a frontal impact where an airbag has been deployed due to a collision. the following MUST be replaced:

-

Front Seat Belt Retractors (driver and passenger) with integral Tensioners. 

All other seat belts should be closely inspected for cuts, tears, fraying, or damage in any way following any frontal impact or airbag deployment. The
other seat belts are to be replaced when visible damage is incurred. Inspect the Lower Anchors and Tether for Children (LATCH) child restraint
anchors for damage after an impact event and replace as needed.

CLEAN UP PROCEDURE

Roll or fold the airbag towards its mounting point (i.e. instrument panel, steering wheel, or roof sill). Then tape the ripped cover over the deployed
airbag if applicable.
Use a vacuum cleaner to remove any residual powder from the vehicle interior. Work from the outside in to avoid kneeling or sitting in a contaminated
area. Vacuum the heater and A/C outlets as well (VACUUM HEATER AND A/C OUTLETS - TYPICAL). If the heater or air conditioner was in
RECIRC mode at time of airbag deployment, operate blower motor on low speed and vacuum powder residue expelled from the heater and A/C
outlets. Multiple vacuum cleaning may be necessary to decontaminate the interior of the vehicle.

Air Bag System|Page 725 > < Refrigerant Oil|Capacity Specifications|Page 719