Viper GTS V10-488 8.0L (1998)
Technical Service Bulletin # 08-49-98
Date: 981127
Electronic Entry Module - Fails To Respond
NO: 08-49-98
GROUP: Electrical
DATE: Nov. 27, 1998
SUBJECT:
Electronic Entry
Module Fails
To Respond
MODELS:
1996 - 1998 (SR) Viper Coupe
1997 - 1998 (SR) Viper Roadster
SYMPTOM/CONDITION:
The Electronic Entry Module (EEM) software may cause the module to fail to respond. If the module has failed to respond, one or more of the following
symptoms may be experienced:
1.
Vehicle does not respond to transmitters operation.
2.
Security alarm LED on the dash is not flashing.
3.
Doors do not open when outside buttons are pressed.
4.
Vehicle theft alarm prevents the vehicle from starting.
5.
Electronic entry module does not communicate with the DRBIII.
6.
On 1998 MY vehicles the park/tail lamps randomly flash for 3 minutes, without a push of the transmitter buttons.
DIAGNOSIS:
Low battery voltage can also cause the above symptoms to be present. Check open circuit battery voltage to ensure that the battery is above 12.0 volts. If
the voltage is below 12.0 volts, correct the condition before proceeding. If any of the above symptoms are identified, perform the Repair Procedure.
PARTS & EQUIPMENT REQUIRED:
1
05015148AA
Electronic Entry Module Kit (1996-1997 MY)
1
04848832AE
Electronic Entry Module (1998 MY)
1
CH6OOO
Scan Tool (DRBIII)(1998 MY)
1
CH7OOO
J1962 (1998 MY)
POLICY: Reimbursable within the provisions of the warranty.
TIME ALLOWANCE:
Labor Operation No:
08-19-24-90
0.5 Hrs
Electronic Entry Module Replace With Transmitters
And Install Antenna (1996 SR)
08-19-24-91
0.4 Hrs
Electronic Entry Module, Replace With Transmitters (1997 SR)
08-19-24-92
0.4 Hrs
Electronic Entry Module, Replace And Reprogram
Transmitters (1998 SR)
FAILURE CODE: P8 - New Part
Repair Procedure
