Viper GTS V10-488 8.0L (1998)
5. Support the brake caliper by hanging it from the upper control arm using mechanics wire. Do not let caliper assembly hang by brake hose.
6. Remove the rotor from the hub/bearing.
7. Remove the remaining hub/bearing to steering knuckle attaching bolts.
8. Remove the hub/bearing assembly from the steering knuckle.
CAUTION: A corrosion prevention gasket is used between the hub/bearing and the steering knuckle. The gasket is required to prevent galvanic
corrosion between the hub/bearing and the steering knuckle. The corrosion prevention gasket must be used when installing a hub/bearing in the steering
knuckle.
INSTALL
1. Install a NEW corrosion prevention gasket on the hub/bearing before installing it in the steering knuckle.
2. Install the front hub/bearing in the steering knuckle. Align the holes in the corrosion gasket with holes in hub/bearing and steering knuckle.
3. Install the 3 bolts mounting the hub/ bearing to the steering knuckle. Tighten the 3 bolts mounting the hub/bearing to the steering knuckle to a
torque of 61 Nm (45 ft. lbs.).
4. Install the rotor on the hub/bearing.
5. Install the brake caliper on the steering knuckle.
6. Install the brake caliper attaching bolts and tighten to a torque of 115 Nm (85 ft. lbs.).
