Viper GTS V10-8.0L VIN E (1999)
NOTE:
The differential support bracket wings may need to be spread slightly to aid in the installation.
17.
Install the new left side differential mounting bolt provided. Do not tighten at this time (Figure 42).
18.
Lightly clamp the differential support bracket to the frame rail (Figure 43).
CAUTION:
Do not over tighten the clamp.
19.
Tighten the differential and pinion crossmember mounting bolts to 100 ft. lbs. (135 N.m).
20.
Tighten the differential mounting bolts at the differential cover isolator bushings to 100 ft. lbs. (135 N.m).
21.
Remove the transmission jack from under the differential assembly.
22.
Remove the left rear shock absorber assembly.
23.
Place a jack stand under the left rear lower control arm and raise the suspension to allow access to drill the in the frame (Figure 44).
24.
Using the differential support bracket as a template, drill two 1/4 inch holes in the frame as shown in Figure 44.
25.
Apply corrosion resistant primer into the holes made in Step 24.
26.
Using the provided structural rivets, attach the differential support bracket to the frame rail using power rivet gun (W-AK175ACH) or equivalent.
27.
Remove the clamp from the frame.
