Viper GTS V10-8.0L VIN E (1999)
6. Remove the master cylinder-to-fluid reservoir seal grommets from the master cylinder.
INSTALL
1. Lubricate the NEW seal grommets for the fluid reservoir with fresh clean fresh brake fluid. Then install new housing-to-reservoir grommets in
master cylinder housing.
2. Lubricate the fluid reservoir mounting area with clean fresh brake fluid. Place fluid reservoir in the correct position over the seal grommets. Seat
the fluid reservoir into the master cylinder using a rocking motion while firmly pushing down on the fluid reservoir.
Fluid Reservoir Installed On Master Cylinder
3. Make sure the fluid reservoir is installed on the master cylinder until the bottom of the reservoir touches the top of both seal grommets.
4. Using a pin punch install the 2 roll pins retaining the brake fluid reservoir to the master cylinder.
NOTE: It is not necessary to bleed the entire hydraulic system after replacing the master cylinder, provided that the master cylinder has been
filled and bled prior to installation.
5. Bleed the master cylinder assembly prior to mounting it on the power brake booster.
6. Install the master cylinder on the vacuum booster.
