Viper GTS V10-8.0L VIN E (1999)
Spark Plug: Service and Repair
SPARK PLUGS
Failure to route the cables properly could cause the radio to reproduce ignition noise, cross ignition of the spark plugs or short circuit the cables to
ground.
REMOVAL
Always remove the spark plug cable by grasping the top of the spark plug insulator, turning the boot 1/2 turn and pulling straight up in a steady
motion.
1. Remove the spark plug using a quality socket with a rubber or foam insert.
2. Inspect the spark plug condition.
INSTALLATION
1. To avoid cross threading, start the spark plug into the cylinder head by hand.
2. Tighten spark plugs to 28 Nm (20 ft. lbs.) torque.
3. Install spark plug insulators over spark plugs.
