Viper GTS V10-8.0L VIN E (1999)
Throttle Cable Retainer Removal
10. In the passenger compartment of the vehicle, hold the accelerator pedal up and remove the throttle cable retainer and throttle cable from the
throttle pedal.
Brake Pedal Retaining Clip
11. Remove the retaining clip from the brake pedal pin using following procedure. Position a small screwdriver between the center tang on the
retaining clip and the brake pedal pin. Rotate blade of screwdriver enough so center tang on retaining clip can pass over end of brake pedal pin.
Then pull retaining clip off brake pedal pin.
12. Remove the wiring harness connector for the clutch position switch from the vehicle wiring harness connector.
13. Remove the actuation rod for the hydraulic clutch master cylinder from the pin on the clutch linkage. Actuation rod is removed from the pin on the
clutch linkage using the following procedure. Position a small screwdriver between the center tang on the retaining clip and the pin on the clutch
linkage. Rotate the blade of the screwdriver enough so that the center tang on the retaining clip can pass over end of pin. Then push the retaining
clip sideways and pull it off of the pin.
14. Remove the actuation rod for the hydraulic clutch master cylinder from the pin.
15. Remove the clutch master cylinder from dash panel. The clutch master cylinder is removed from the engine side of the dash panel by rotating it
counter-clockwise until it disengages from the pedal assembly bracket on the inside of the vehicle. Move the clutch master out from the dash panel
until it hits the left inner fender. This is required to avoid hitting and damaging the master cylinder when removing the pedal assembly.
16. Unclip the stop lamp switch wiring harness from the bracket of the pedal assembly.
