Viper GTS V10-8.0L VIN E (1999)
4. If the dimension is approximately 1-5/8 inches, the cam gear will have to be rotated.
5. Attach a socket to the vibration damper mounting bolt and rotate engine until the 1-15/32 inch dimension is attained.
6. Install the sensor into the timing case/cover with a slight rocking action. Do not twist the sensor into position as damage to the O-ring may result.
Push the sensor all the way into the cover until the rib material on the sensor contacts the camshaft gear.
7. Install the mounting bolt and tighten to 6 Nm (50 in. lbs.) torque.
8. Connect sensor wiring harness to engine harness.
when the engine is started, the rib material will be sheared off the face of sensor. This will automatically set sensor air gap.
