Viper GTS V10-8.0L VIN E (1999)
11.
Adjust the front caster angle using the measurements viewed on the DRB III screen, and the camber angle using the measurements viewed on the
alignment equipment. Camber and caster angles are adjusted by turning the cam bolts on the lower control arm bushings (Figure 24). Refer to the
Alignment. Specifications Chart in this document.
12.
Set the front and rear static wheel toe using the following procedure.
NOTE:
The engine should be running during the front wheel toe setting procedure.
a.
Start the engine and turn the wheels both ways before straightening and centering the steering wheel. Center the steering wheel and retain the
steering wheel position with a steering wheel clamp.
b.
Loosen the front outer tie rod end jam nut (Figure 25).
c.
Remove the clamp from the front inner tie rod boot (Figure 25).
