Viper GTS V10-8.0L VIN E (1999)
J. Replace Rear Toe Link Bracket
1.
Remove the cotter pin and castle nut for the right and left toe link.
2.
Remove the right and left toe link from the knuckles using puller, Special Tool C-3894-A (Figure 32).
3.
Remove the right and left side toe link inner and outer attaching bolts and nuts (Figure 33).
CAUTION:
The toe link outer mounting bolt location is used to adjust the rear wheel dynamic toe pattern. The rear wheel dynamic toe is adjusted by installing an
adjustment shim at this location. When removing the outer mounting bolt and nut, be sure that the adjustment shim is not discarded. Also note the
side of the vehicle and mark the adjustment shim position prior to removal. It must be installed in the same position when reassembled.
4.
Remove the toe link assemblies from the vehicle by sliding them out of the toe link bracket through the rear wheel opening.
