Viper GTS V10-8.0L VIN E (1999)
Special Tool C-4150A And Spacer Special Tool 6983 Correctly Positioned
11. Install Puller, Special Tool C-4150A, on steering knuckle. The ball bearing in the bolt of Special Tool C-4150A must be centered in the stud of the
lower ball joint. Also, the Spacer, Special Tool 6983, must be installed between the steering knuckle and Special Tool C-4150-A, as shown.
Upper Ball Joint To Steering Knuckle Attachment
12. Remove the cotter pin and nut attaching the upper ball joint stud to the steering knuckle.
CAUTION: Do not strike the steering knuckle or apply heat to the steering knuckle, when separating the ball joint stud from the steering knuckle.
Ball Joint Removal From Steering Knuckle
13. Remove the upper ball joint stud from the steering knuckle using Remover, Special Tool C-4150A.
14. Remove the steering knuckle from the upper, and lower control arm.
15. Transfer the front hub/bearing to the replacement steering knuckle.
