Viper RT-10 V10-8.0L VIN E (1997)
8.
Remove the rear stabilizer bar.
9.
Remove the right wheel opening splash shield.
10.
Using a cut off wheel, remove all welds that hold the toe link bracket to the frame cross brace. Discard the old toe link bracket.
CAUTION:
Do not use plasma arc cutting equipment or cutting torch to remove the toe link.
11.
Clean and prepare areas on the frame cross brace and toe link bracket where new welds will be applied.
12.
Locate the center point between the two weld nuts on the new toe link bracket. Place a scribe mark at that point (Figure 35).
13.
Locate and clamp into place the new toe link bracket onto the frame cross brace by aligning the scribe marks (Figure 36).
14.
Tack weld the toe link bracket into position.
