Viper RT-10 V10-8.0L VIN E (1997)
5. Install the bolt mounting the side of the clutch/brake pedal mounting bracket to the toe box area of the dash panel.
6. Tighten the clutch/brake pedal mounting bracket attaching bolts and nuts in the following sequence and torques listed below.
^
Tighten clutch/brake pedal mounting bracket to vacuum booster nuts to a torque of 29 Nm (250 inch lbs.).
^
Tighten clutch/brake pedal mounting bracket to dash panel upper mounting bolts to a torque of 20 Nm (180 inch lbs.).
^
Tighten clutch/brake pedal mounting bracket to side dash panel mounting bolt to a torque of 4 Nm (35 inch lbs.).
7. Install the powertrain control module on the dash panel. Be sure ground wire is installed on the front mounting screw of the powertrain control
module.
8. Install the shield covering the powertrain control module.
NOTE: Be sure sealant is installed on back surface of stop plate.
9. Install the accelerator pedal on dash panel. When installing accelerator pedal be sure stop plate is installed under the accelerator pedal.
10. Install accelerator pedal mounting nuts on engine side of dash panel. Tighten both mounting nuts to a torque of 12 Nm (105 inch lbs.).
11. Using Mopar Lubricate or an equivalent, lightly lubricate the surface of the brake pedal striker which the plunger of the stop lamp switch contacts.
