Viper RT-10 V10-8.0L VIN E (1997)
CAUTION: When pushing the pistons back into the bores of the caliper, use only a trim stick as shown above or other suitable soft tool. Never use a
screw driver or other metal pry bar due to potential damage to the braking surface of the rotor surface.
1. Install the previously removed brake shoes back into the caliper. Place a trim stick at the center groove of the inboard brake shoe and the outer
edge of the rotor. Using the trim stick, apply pressure against the inboard brake shoe assembly until both pistons are completely bottomed in the
bores of the inboard caliper half. Move the trim stick between the outboard brake shoe and the rotor and repeat above the procedure.
2. Install the new inboard and outboard brake shoes into the disc brake caliper.
