Viper RT-10 V10-8.0L VIN E (1997)
Piston Seal Installed In Caliper
14.
Dip the new piston seal in fresh clean brake fluid. Position the seal into the seal groove in the piston bore of the caliper. Then using your fingers
gently work piston seal into seal groove in caliper bore until the seal is properly seated.
15.
Lightly coat the inside of the new dust boot with fresh clean brake fluid. Then install the new dust boot on the caliper piston. Be sure the dust boot
is completely seated in the retaining groove in the caliper piston.
NOTE: Force must be applied to the piston uniformly to avoid cocking and binding of the piston in the bore of the caliper.
Piston Installed In Caliper Bore
16.
Squarely install the piston into the top portion of caliper bore. Then using your fingers evenly apply pressure to the piston, pressing it into the bore
of the caliper until it is past the piston seal and bottomed in bore
