Viper RT-10 V10-8.0L VIN E (1997)
5. Attach clear hose on bleeder screw located on the top of the outboard half of front caliper assembly being bled. Put open end of hose into a
clear container partially filled with fresh clean brake fluid.
6. Repeat steps 2 and 3 above on outboard half of the caliper assembly. Then close the bleeder screw on the outboard caliper.
7. Remove hose from bleeder screw, and torque the bleeder screw to 10 Nm (88 inch lbs.).
8. Again attach clear hose to bleeder screw located on the top of inboard half of front caliper assembly being bled. Put open end of hose into a
clear container partially filled with fresh clean brake fluid.
9. Again repeat steps 2 and 3 above on the inboard half of the caliper assembly. Then close the bleeder screw on the outboard caliper.
10. Remove hose from bleeder screw, and torque the bleeder screw to 10 Nm (88 inch lbs.).
REAR BRAKES
1. Attach a clear hose onto the bleeder screw located on the top of the caliper assembly. Put open end of hose into a clear container partially filled
with fresh clean brake fluid.
2. Open the bleeder screw on the caliper assembly at least ONE FULL TURN or more.
3. After 4 to 8 ounces of fluid has been bled through the brake system. And an air-free flow is maintained in the clear plastic hose and no bubbles
are present in the container, this will indicate a good bleed.
4. Close the bleeder screw, and remove hose. Torque the bleeder screw to 10 Nm (88 inch lbs.).
