Viper RT-10 V10-8.0L VIN E (1997)
Idle Speed/Throttle Actuator - Electronic: Service and Repair
Fig. 36 Idle Air Control Motor
The IAC motor is inserted into a housing at the front of the intake manifold (Fig. 36). The IAC motor and housing are serviced together.
REMOVAL
1. Remove hose clamp and inlet air hose from Idle Air Control (IAC) Motor.
2. Remove housing to manifold screws.
-
Remove IAC motor and housing.
3. Disconnect the electrical connector from IAC motor.
INSTALLATION
1. Attach electrical connector to IAC motor.
2. Install IAC motor into and housing on manifold.
-
Tighten mounting screws to 11 Nm (97 in. lbs.) torque.
3. Install air inlet hose to IAC motor.
-
The hose is marked engine end. Connect this end to IAC motor.
