Viper RT-10 V10-8.0L VIN E (1997)
Coolant Temperature Sensor/Switch (For Computer): Testing and Inspection
Sensor Test
1. With the key off, disconnect wire harness connector from coolant temperature sensor.
2. Connect a high input impedance (digital) volt-ohmmeter to terminals A and B. The ohmmeter should read as follows:
-
Engine/Sensor at normal operating temperature around 200°F should read approximately 700 to 1,000 ohms.
-
Engine/Sensor at room temperature around 70°F ohmmeter should read approximately 7,000 to 13,000 ohms.
3. Test the resistance of the wire harness between the PCM Gray 32 way connector terminal 15 and the sensor harness connector.
-
Also check for continuity between PCM Black 32 way connector terminal 4 and the sensor harness connector. Refer to Wiring diagrams for
circuit information. If the resistance is greater than 1 ohm, repair the wire harness as necessary.
