Viper RT-10 V10-8.0L VIN E (1997)
Camshaft Position Sensor: Service and Repair
Sensor Removal-Replacing Old Sensor With Original
Fig 29 Camshaft Position Sensor Location
The camshaft position sensor is located on the timing chain case/cover on the left-front side of the engine (Fig. 29).
Fig 30 Sensor Depth Positioning Rib -- Typical
A thin plastic rib is molded into the face of the sensor (Fig. 30) to position the depth of sensor to the upper cam gear (sprocket). This rib can be found on
both the new replacement sensors and sensors that were originally installed to the engine. The first time the engine has been operated, part of this rib may
be sheared (ground) off. Depending on parts tolerances, some of the rib material may still be observed after removal.
If the original camshaft position sensor is to be removed and installed, such as when servicing the timing chain, timing gears or timing chain cover, use
this procedure.
REMOVAL
1. Disconnect the sensor harness connector from the sensor.
2. Scribe the sensor for location depth.
3. Remove the sensor mounting bolt (Fig. 29).
4. Carefully pry the sensor from the timing chain case/cover in a rocking action with two small screwdrivers.
5. Remove the sensor from vehicle.
6. Check condition of sensor O-ring.
