Viper RT-10 V10-8.0L VIN E (1997)
INSTALLATION
1. Install new switch as shown. Be sure that the spring loaded plunger inside the switch is slightly compressed. The plunger inside the switch must go
on the narrow section of the clutch master cylinder actuation rod. Place the top of the switch against the rod. Then push the switch up slightly. This
will compress the plunger. Then push the bottom of the switch against the rod. Failure to install the switch as described or forcing the switch onto
the rod will crack the switch.
2. Install new white plastic retaining clip.
3. Install the clutch master cylinder back into the vehicle.
4. Reconnect the clutch switch connector.
5. Check clutch position switch operation.
