Viper RT-10 V10-8.0L VIN E (1997)
3.
Using two adjustable pin spanner wrenches (Snap-on P/N APS357B, OTC P/N JHW-O-472 or equivalent), one on the lower spring seat and the
other on the lock nut below it, loosen and back off the lock nut (Figures 68 and 69).
4.
Using one of the adjustable pin spanner wrenches, rotate the lower spring seat in the direction needed.
NOTE:
If the vehicle was lower than curb height specification, rotate the spring seat upward. If the vehicle was higher than curb height specification,
rotate the spring seat downward.
5.
Once preferred spring height is achieved, thread the lock nut up against the bottom of the lower spring seat.
6.
Place an adjustable pin spanner wrench on the lower spring seat to hold it in place, then tighten the lock nut up against the lower spring seat.
7.
Remove the shock absorber/coil spring assembly from the vise.
8.
Repeat steps 2 through 7 for the other shock absorber/coil spring as necessary.
9.
Install front and/or rear shock absorber/coil spring assemblies onto the vehicle.
CAUTION:
When installing shock absorber/coil spring assemblies, the vehicle must be at design height before tightening the upper and lower mounting
bolts to specifications.
10.
Continue with Section "0 - Setting the Vehicle Design Height."
