Viper RT-10 V10-8.0L VIN E (1997)
Clutch Release Bearing: Service and Repair
NOTE: The transmission must be removed from the vehicle to replace the hydraulic ram assembly. The bearing and slave cylinder are serviced together
as an assembly. Do not attempt to separate the bearing from the slave cylinder.
REMOVAL
1. Raise vehicle on hoist.
2. Disconnect hydraulic line from hydraulic slave cylinder. Use the quick disconnect tool (special tool 6638, or equivalent) to open the coupling.
3. Remove transmission assembly from the vehicle.
4. Remove slave cylinder from transmission.
INSTALLATION
To install, reverse above procedure.
