Viper RT-10 V10-8.0L VIN E (1997)
3.
Remove the two rear muffler isolators (Figure 13).
4.
Remove the muffler/rear exhaust pipes as an assembly.
5.
Remove the inner axle shaft universal joint straps from the left axle shaft.
NOTE:
Mark universal joint cap for later installation.
6.
Remove the inner axle shaft universal joint straps from the right axle shaft.
NOTE:
Mark universal joint cap for later installation.
7.
Remove the universal joint bolts and straps at the rear of the driveshaft.
NOTE:
Mark universal joint cap for later installation.
8.
Remove the driveshaft assembly from the transmission.
9.
Remove the pinion-to-crossmember mounting bolts from the front of the axle assembly.
10.
Secure the differential assembly to a transmission jack or other suitable lifting device.
11.
Remove the right and left differential mounting bolts.
12.
Remove differential assembly from the vehicle.