Viper RT-10 V10-8.0L VIN E (1997)
7.
Once the inclinometers are attached to the rear Caster Angle Fixtures, they can be mounted on the rear knuckle caster angle pads as shown in
Figures 57.
CAUTION:
The caster pads are located on the rear edge of the rear knuckle. Be sure that the caster pads are thoroughly cleaned before mounting the caster
inclinometers on the knuckles. The caster inclinometers must sit flat on the caster pads to obtain accurate caster readings.
8.
Adjust the rear caster angle using the measurements viewed on the DRB III screen, and the camber angle using the measurements viewed on the
alignment equipment. Camber and caster angles are adjusted by turning the cam bolts on the lower control arm bushings (Figure 58). Refer to the
Alignment Specifications Chart in this document.
9.
Transfer the inclinometers to the front Caster Angle Fixtures (Special Tool # 6915) (Figure 59).
10.
Once the inclinometers are attached to the front Caster Angle Fixtures, the fixtures can be mounted on the front knuckle caster pads as shown in
Figures 60.
CAUTION:
The caster pads are located on the front edge of the front steering knuckle. Be sure that the caster pads are thoroughly cleaned before
mounting the caster inclinometers on the front steering knuckles. The caster inclinometers must sit flat on the caster pads to obtain accurate
caster readings.
