Viper RT-10 V10-8.0L VIN E (1997)
Gear Lockout Solenoid: Description and Operation
2/3 Lockout Solenoid
CIRCUIT OPERATION
2/3 Lock Out Solenoid
The 2/3 lock out solenoid is used to prevent the operator from shifting into second or third gear under certain operating conditions.
Power for the solenoid is supplied on circuit F12. This circuit is HOT when the ignition switch is in the START and RUN position. The F12
circuit is protected by a 10 amp fuse located in cavity 10 of the fuse block.
Ground for the solenoid is controlled by the Powertrain Control Module (PCM), on circuit K33. This circuit connects to cavity C6 of the PCM
connector.
To energize the solenoid, the PCM provides a ground path for circuit K33.
