Viper SRT-10 V10-8.4L (2008)
Front Door Weatherstrip: Service and Repair
Windshield Header & A-Pillar Weatherstrip
Removal
REMOVAL
1. Remove the a-pillar trim. See: Interior Moulding / Trim/Trim Panel/Service and Repair/Pillar Trim/A-Pillar Trim Panel-Removal
2. Remove the nuts and push pins.
3. Remove the weatherstrip.
Installation
INSTALLATION
1. Clean the header with a suitable cleaner.
2. Install the weatherstrip making sure a tight joint to the primary weatherstrip exists.
3. Install the weatherstrip push pins and the nuts and tighten the nuts to 6 Nm (55 in. lbs.).
4. Install the a-pillar trim. See: Interior Moulding / Trim/Trim Panel/Service and Repair/Pillar Trim/A-Pillar Trim Panel-Installation
