Viper SRT-10 V10-8.4L (2008)
7. Remove the screw at the rear of the console.
8. Remove the two screws at the door edge.
9. Pull back panel up and route the seat belt through the panel.
10. Move the passengers seat forward.
11. Remove the lower seat belt anchor.
12. Remove the sill plate.
13. Remove the sport hoop fastener cover.
14. Remove the two bolts and remove the sport hoop (Convertible only).
15. Remove the screw at the rear of the console.
16. Remove the two screws at the door edge.
17. Pull back panel up and route the seat belt through the panel.
18. Remove the trim panel.
19. Disconnect the speaker electrical connectors.
20. Remove the nuts and remove the convertible top latch assembly.
21. Remove the four bolts in the front of the support panel.
22. Remove the two nuts in the rear of the support panel and remove.
Bulkhead Trim Panel - Coupe
INSTALLATION