Viper SRT-10 V10-8.4L (2008)
Seat Back: Service and Repair
Seat Back Cover
Seat Back Cover - Removal
REMOVAL
1. Open deck lid.
2. Remove four bolts to battery compartment cover and remove cover.
3. Disconnect and isolate the battery negative cable.
WARNING: Wait two minutes for the system reserve capacitor to discharge before servicing any airbag components. Failure to do this
may result in serious or fatal injury.
4. Remove the seat from vehicle See: Service and Repair/Seat/Seat - Removal.
5. Unzip the seat back cover (4) and expose the recliner bolts (2).
6. Remove the recliner bolts and remove the seat back.
7. Disconnect the j-straps at the bottom of the seat back.
8. Remove the seat back cover hog rings.
9. Position the seat back cover/cushion aside and release the seat belt pass through bezel (1) locking tabs (2).
10. Remove the seat belt pass through bezel (1).
11. Remove the seat back cover and cushion.
Seat Back Cover - Installation
INSTALLATION